The installation position of the submersible pump must be appropriate, the height of the water pump must enable the pump to inhale enough vacuum, and the installation position of the water pump must be level and stable, so as to achieve the maximum working efficiency of the water pump. It is necessary to ensure that the axis is on the same straight line, so as to avoid the wear of one side caused by the vibration of the pump and the friction of the bearing. When the belt is used to drive the impeller to rotate, the belt should be aligned.

There are many pumps in some pump rooms. At this time, it is necessary to maintain the direct distance between the pumps. Each pump must be stable to prevent the pump from moving and colliding when it is working. The suction pipe of the water pump must be sealed well, and no elbow is used, because it is easy to leak and reduce the amount of water pumped.
If it is a submersible pump, it must be placed in a place where the water source is relatively deep, and a separate pit can be dug in the water, so as to ensure that enough water can be transported out, and to ensure that there is no silt, otherwise It will cause blockage of the pump.