The basic structure of the swimming pool pump is divided into three parts: the hair filter in the front section, the water pressure chamber in the middle section, and the motor section. Due to the special structure of the pump body, impeller and mechanical seal, the pump shaft is not in touch with the liquid. All parts which touch with liquid are made with plastic, which is safe, hygienic and non-corrosive.

The IP protection of swimming pool pump is IPX6, which is the highest Isolation Protection for the similar products. The Swimming Pool Pump implements the JB/T 6435-2013 standard. It has the characteristics of high efficiency, low noise, mild corrosion resistance, compact structure, beautiful appearance, small size, light weight and so on. The pump is suitable for low-viscosity, neutral, non-explosive, solid particles or fiber-free liquids.

Using conditions:

PH value: 5-12

Ambient temperature: 0-40°C

Environmental humidity: max.85% (RH)

Medium temperature: 0-60°C

(Under special circumstances, the temperature of the medium used shall be not exceed 90°C)

Application:

1. Swimming pools for residential and commercial purpose.

The water for swimming pool pump is not changed frequently, but is used repeatedly through filtration and cycle every day. If the pump equipped with our SELF-DEVELOPED filter cartridges, the water can be second-filtering. And a ultraviolet sterilizer can be also added in the whole system. The bacteria and algae in the water will be killed by the sterilizer.

2. Commercial bathing centers and bathhouses.

The hair filter is a mandatory requirement for swimming pool pumps. The pump body is made of plastic to ensure the water is safe, hygienic and rust-free. The pump head for traditional swimming pool pump is cast iron, which is easy to leak liquid and get rusty.

In terms of the secondary fine filter, the PP filter bag in filter cartridge can effectively replace the sand tank filter. The sand tank filter is not suitable for the bathhouse, because the water quality of the bathroom contains a lot of grease, cleaning agent, so it is easy to solidify the quartz sand in the sand crock pot. But our PP belt filter can effectively filter grease and debris. And it is easy to clean and replace the consumables, and the consumables are cheap and easy to buy in the market.

3. Seafood market, seawater and freshwater for hotel fish tank and pond.

The pump head part takes PA+nylon engineering plastic material. The special material and structure of the pump body are very suitable for water circulation in these environments, whether it is seawater or freshwater. No rust, no corrosion, quiet operation and large flow rate.

4. Seaside mariculture and seawater irrigation.

The ultra-high IP X6 protection level fully meets the high heat, high humidity and high salt working environment of the pump outdoors by the sea. The motor can run for a long time. Ensure that clean and fresh seawater is continuously injected into the breeding tank. However, in the case of long-distance power supply, it is necessary to ensure that the access power line needs to be more than 1.5 times the diameter of the original power line of the pump. The voltage ensures that the fluctuation range is within plus or minus 10% of the rated voltage of the pump. In order to avoid the impact of high current on the motor.

Installation dimension drawing